Guide

How to Use Pods in a Washing Machine

Updated on · By the Keen Wash team

Put one pod in the empty drum first, then load the clothes on top. Never put a pod in the detergent drawer, and never use one in a load shorter than your pod's directions allow.

On this page (9 sections)
  1. Where do you put a pod in a washing machine?
  2. Do you put clothes in before or after the pod?
  3. Which cycle should you choose for pods?
  4. How many pods does one load need?
  5. Can you use pods in every wash cycle and temperature?
  6. Will pods clog the dispenser or the machine?
  7. Are pods safe for all washers, and what should you skip?
  8. What goes wrong, and how do you fix it?
  9. Should you use pods or liquid or powder?

Here's how to use pods in a washing machine: put one pod in the empty drum first, add the clothes on top, and start your cycle. Skip the detergent drawer completely, and pick a cycle long enough for the film to dissolve.

The method is that simple. Most problems with pods come from where you place them and what cycle you choose, not from the pod itself.

Where do you put a pod in a washing machine?

The pod goes in the empty drum, at the back, before any clothes. Dropping it in first lets it sit where water hits it early and start dissolving before it gets buried in fabric.

Never put a pod in the detergent drawer. The drawer isn't built for a solid concentrate, and the film can gum up the channel that carries detergent into the drum.

On a front loader, push the pod toward the back of the stainless steel drum so it doesn't rest against the door seal. On a top loader, drop it in and let it settle at the bottom before you add laundry.

The LG WM4200HWA has a 5.0 cu ft drum, so a single pod has room to dissolve even in a bulky load.

The drum is stainless steel, which resists the film and scum that pods can leave behind on softer surfaces.

That rear placement matters most when the drum is full. The LG's maximum spin speed of 1300 rpm means water moves through the drum quickly, so a pod sitting against the front glass has less time in the water it needs.

Do you put clothes in before or after the pod?

Add clothes after the pod, and don't pack the drum full. Loose clothes let water and the dissolving film move freely, so the pod doesn't get trapped against fabric.

If you load first, you're guessing where the pod lands. It can wedge into a sheet or a shirt pocket and leave a gummy patch that's hard to rinse out.

Leave a hand's width of space at the top of the drum. Overloading is the most common reason a pod leaves residue, and it's also hard on the machine over time.

The bigger the drum, the easier this is to get right. A 5.0 cu ft tub like the LG's leaves more open space around a bulky comforter than a smaller washer does, so the pod has room to tumble instead of being pressed into fabric for the whole cycle.

Which cycle should you choose for pods?

Pick a full-length cycle that matches the fabric, not a rinse-only or quick-wash setting. Pods need time and water to break down the film and mix the concentrate evenly.

A 15-minute speed cycle usually doesn't give the pod enough contact time. That's especially true in cold water, so check the pack for any minimum temperature.

The Kenmore 4.5 Cu Ft Front Load Washer runs an Express Wash that cleans a small 3-lb load in 25 minutes, which is long enough for a pod in most cases. Its Steam Treat option helps on stained loads without changing pod placement.

The washer offers 12 wash cycles, including Kids Wear, Whites, Delicates, and Cold Clean, so there's a matching cycle for most pod loads without reaching for a short setting.

How does TurboWash change pod timing?

The LG WM4200HWA pairs its 14 wash cycles with TurboWash 360°, which speeds up the wash without cutting the cleaning result short. Before you run a pod on a TurboWash cycle, check that the cycle still meets the pod's minimum time and temperature.

Use the pod's temperature guidance first, then let TurboWash handle the time saved.

How many pods does one load need?

One pod per normal load, and no more. Pods are pre-measured, so adding a second one doesn't clean better and can leave extra residue in the drum and hoses.

Some packs print guidance for large or heavily soiled loads. Follow the pack, not a habit of doubling up.

Never cut, tear, or pierce a pod to adjust the dose. The concentrate is meant to stay inside the water-soluble film until it reaches the drum.

Can you use pods in every wash cycle and temperature?

Pods work in most cycles, but the pack's temperature range matters. Many dissolve in cold water, yet some formulas perform better once the water reaches a stated minimum.

For cold washes, check whether the pack lists a cold-water claim before you rely on it. If it doesn't, save pods for warm or hot loads.

Don't place a pod in the drum and walk away before starting the machine. If moisture reaches it early, the film can start breaking down in the wrong spot.

If your washer has a steam cycle, the heat adds a reason to match the pod to the load. On the LG, Steam Wash and the Allergiene cycle run hotter than a plain cold wash, so a pod placed at the back of the drum gets the warm water it needs to break down fully.

Will pods clog the dispenser or the machine?

Pods don't touch the dispenser when you use the drum, so there's nothing to clog. Residue problems come from a pod in the drawer or from a pod left undissolved in an overloaded drum.

Over months, a slow-dissolving pod habit can leave film and soap scum inside the drum and around the pump. That's where a monthly cleaner earns its place.

The Affresh Washing Machine Cleaner is designed to power away bacteria, grime and soap scum in the pump, drum and filter. One tablet once a month covers the cleaning, and it's safe for front and top loaders.

The time-release tablet keeps working through the cycle, so it reaches the pump and filter where pod film tends to collect.

Run your machine's clean cycle with the tablet and no laundry, then wipe the door or lid area. Our guide to how to clean a washing machine rubber seal covers the spots film likes to hide.

Are pods safe for all washers, and what should you skip?

Pods are safe in most front and top loaders, but some machines advise against them. Check your manual first, then confirm the cycle is long enough for the film.

Skip pods in rinse-only runs, hand-wash settings, and very short cycles. They don't give the film enough time, and fabric can come out with a sticky spot.

Skip them in the detergent drawer, in a load already full of powder, and in a machine you're washing with a cleaner tablet in the same run. Keeping detergent and cleaner apart protects both jobs.

A cleaner tablet already has the run to itself, so adding a pod only leaves film the tablet has to chase.

Pods sit in heated drum space and dissolve in water, so they put less strain on the drawer and hoses than powder does. Still, a healthy machine matters more than the detergent format; our post on how long should a washing machine last shows what an aging machine can't take.

Hoses wear too, so read how often to replace washing machine hoses before a burst catches you out.

If you want a broader run-through of the risks, are laundry pods safe for washing machines covers the safety side in detail.

What goes wrong, and how do you fix it?

Residue, a pod stuck to clothes, and a film patch in the drum are the usual failures. They all trace back to placement, overload, or a cycle that was too short.

If you see a sticky patch after the wash, stop the machine, pull the item out, and rinse it by hand in warm water. Run a hot wash with no laundry to clear film from the drum.

A pod that never dissolved may still be in the drum after the cycle. Rinse the drum and drop the next pod in before the clothes, not after.

Crumpled film around the door seal is a sign pods are sitting against the front of a front loader. Move each pod to the back of the drum on the next load.

The front loaders here open at the front, so the seal is the spot to check after a failed cycle.

Should you use pods or liquid or powder?

Pods suit people who want pre-measured doses and no drawer cleanup, and liquid or powder suit anyone who likes to adjust the amount. Both clean well when the cycle is right.

Pods are easy to overuse by accident because there's no measuring, but they're hard to underdose. Liquid is easier to tweak for a small load or a gentle cycle.

If you use pods often, keep a cleaner routine on the calendar. The scum they can leave builds quietly in the spots you can't see.

A once-a-month tablet keeps that build-up from turning into a smell or a pump problem.

If your machine has a pod setting or a detergent recommendation printed in the manual, follow it over any general rule. Your washer's own guidance always wins, but the steps above answer the question in practice.

Once you've got the order down, how to use pods in a washing machine comes down to one habit: pod first, clothes second, full cycle. That habit alone prevents most residue problems.

Frequently asked questions

Will a pod dissolve in a cold wash?

Most pods are made to dissolve in cold water, but check the pack for its lowest stated temperature. If it gives a minimum, run a warmer cycle instead of hoping the film breaks down.

Can I tear a pod in half for a small load?

No. Breaking the film spills concentrate onto your hands and clothes and leaves you guessing at the dose.

For a small load, use a pod only if the pack allows it, or switch to liquid.

What happens if I put a pod in the detergent drawer?

It usually dissolves slowly and leaves sticky film in the drawer and the hose into the drum. The film can also clog the drawer channel over time, so pods always go in the drum.

Can I use pods in a portable washer?

Only if the washer's manual allows pods and the cycle runs long enough for the film to break down. Short portable cycles often leave pod residue, so liquid detergent is the safer default.